Pages

Tuesday, 27 October 2026

Even more thinking about hexes

When I tried to create the very large hex I featured in my previous blog post, I discovered that I need to go to our storage unit to collect some more of my Hexon II hex terrain before I can. Feeling rather at a loose end, I decided to see if I could fit a large hex/smaller hexes combination onto my existing Portable Wargame warboard. Initially, the result looked like this:

I did not like this lopsided arrangement ... but realised that if I made a few minor adjustments to the number of hexes and half-hexes that I used on my warboard, it looked a lot better!

This new arrangement would require 3 x six-hex blocks (or the equivalent 18 single hexes), 19 x single hexes, and 22 x half-hexes as opposed to the 8 x six-hex blocks (or the equivalent 48 single hexes) and 6 x half-hexes used in my original layout.

For comparison purposes, I reproduced the terrain map for The evacuation of Abou Nasir that I had previously used as an example, and the end result looked like this:

Whilst it is by no means perfect (In the example, the village is spread over both of the large hexes whereas I would prefer it to only be in one of them), I does give me an alternative way forward that I had not previously thought might be possible.

It's not quite a 'back to square one' situation ... but it is certainly a new jumping-off point!

8 comments:

  1. I see this gives you a little less area at 6x8 hexes than your normal gaming size of 8x9.
    My question is what are you looking for the large hexes to provide? Is it area map movement?

    ReplyDelete
    Replies
    1. WEK 1,

      I am thinking of using the larger hexes for area movement, and when opposing forces arrive in adjacent hexes, the action is transferred to this setup.

      All the best,

      Bob

      Delete
  2. This all seems terribly complicated, although interesting from a Hexon geometry pov. Couldn't you just use the strategic map hexes as a guide to the tactical terrain, but lay out the battle on a normal 8x9 Hexon configuration? The only game I've played on an actual hex shaped table was Phil Sabins 'Phalanx', and I'm not sure it added much to the proceedings.

    ReplyDelete
    Replies
    1. Martin Rapier,

      This may well be a dead end … but like so many ideas in game design, it’s worth exploring before rejecting it as a line of development. It does seem complicated and there are simpler ways to transfer action from the campaign map to the tabletop … but if I can crack it, then I’ll have developed something that other people may choose to carry forward.

      All the best,

      Bob

      Delete
  3. It seems like the benefit here is that the system is scalable. You can conceivably fit any number of smaller hexes in a larger hex given that the shapes are consistent. I remember seeing this in early editions of the Advanced D&D rules and Dungeon Master's Guide. The really nice thing about hexes and squares is that it's easy to divide a larger one into smaller ones while keeping the same geometry, even if it leaves you with half-hexes.

    ReplyDelete
    Replies
    1. Mr. Pavone,

      It certainly is scalable, as my 'experiments' have shown. However, I'm not sure that this is an avenue that I want to pursue for the present.

      All the best,

      Bob

      Delete
  4. BOB,
    I like reading about your 15mm miniature soldiers- not so much about grids. All the best. KEV.

    ReplyDelete
    Replies
    1. Kev Robertson,

      I am currently in one of my 'wargame design' phases. Don't worry, I'll be back playing with my 15mm figures soon!

      All the best,

      Bob

      Delete

Thank you for leaving a comment. Please note that any comments that are spam or contain phishing messages or that come from Google Accounts that are 'Unknown' will be deleted.